Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Attach with the design concept which I going to configure on the Cisco 7613 router as Core backbone router. My question is does this design can work as 3 backup route into one single E1.below is my current configuration on Cisco 7613 router, Hope som...
We have CSS11105s running but having some problems getting the load balancing to work as we wanted. We are looking into activating DFP but unable to locate DFP agents for Solaris. Cisco's recommended "SiteAssure" software doesn't seem to be availab...
I'm using this command in order have to have VIP source ip address. However, I am confused with the "add service" and "add destination service" under this group command. Reading the documentation adds to the confusion. How do we use these commands...
Sounds simple but I'm unable to locate the command to clear these statistics other than a reboot.We are testing the CSS 11500 and trying to determine the hit counts. Clearing these statistics would be very helpful. Help is much appreciated! Regard...
We have configured box-to-box redundancy and it works fine. However, it seemed to fall squarely on a single point of failure - the heartbeat link between the 2 CSS. Could we have more than 1 physical crosscable connection between the 2 CSS?
Hi Gilles,the CSS is actually CSS11501 - sorry for the typo.We have a few servers load balanced in a one-armed configuration. These servers provide multiple services and we are using "balance aca" on the content VIP with src-ip stickyness enabled.No...
Hi Sagar,thanks for the reply. I am using a one-armed configuration but via two Ethernet ports (same vlan) for in/out traffic on the CSS.I noticed CSS redirects the traffic to serves using the original source IP but with CSS MAC address.Wouldn't th...
We had this exact question posed to us on the single point of failure scenario!Now, for active-active ASR, you have 'isc-port'. Is that used for stateful failover flow of information? Therefore, any failures on this port would not pose a problem ot...
