Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I have an interesting request from a remote-site not wanting to allow access to a public facing IP. We have a tunnel between their ASA & ours which hairpins traffic to 2 networks out the outside interface.
(IPs have been changed to protect the innoc...
UPDATE:
I ended up routing this traffic Inside instead of haripinning. Funny thing is it still didn't work until I removed the network objects referenced in the NAT statement & added them back. Since that fixed it, I didn't care to try it with the ...
I know this is an old post, but saw your last comment while searching for other info.
license boot module module-name level license-level
"?" out the command to see what fits your needs.
I'm not personally familiar with the 1900 series, but on a ...
No, it will not accept that command. I think I can only use that if I'm keeping the NATs the same on the statement.
Sorry for the delay- I was waiting on feedback if I could have the remote ASA NAT to the real IP before the tunnel but was just den...
