Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
We've successfully implemented NAT using IOS on two 6509's at our site. We'd like to extend our use of NAT to a few other routed segments that apparently have no (local) NAT support. Suprisingly 3550 and 3750 w/ enhanced images - even the Advanced s...
I've heard some rumbling that not all GBIC/SFP products will work in Cisco switches because they are not "genuine Cisco" and Cisco switches have some way of checking to make sure they are. I can't seem to get any search hits confirming this. Can anyo...
We've traced a problem with our setup of a CSS11503 w/ 1 SSL card and WebCT/Vista to the following cause. The WebCT/Vista app expects to see the header WL-Proxy-SSL: truewith every HTTP request, so we added the following line to to the ssl-proxy-...
On a Cat-OS 6509 running 7.6(9) I'm seeing an intermittent (a few times a day) what appears to be a spanning tree event in:Feb 9 21:34:05 10.5.0.5 SPANTREE-2-RX_1QPVIDERR: Rcved pvid_inc BPDU on 1Q port 3/7 vlan 156Feb 9 21:34:05 10.5.0.5 SPANTREE-2-...
Problem solved - exactly as you stated. It took me a while to figure out I had an ACL that was in the way on the routed links.Thanks so much for your help!
GP,I probably wasn't clear. We have 2 border routers - both running NAT successfully via IOS on these 6509's/Sup720's. What I want to do is NAT some 10.x addresses living on routers other than the 2 border routers. Unfortunately these other routers (...
Hmmm ... Cisco let's you config 6500's as a router and ours also act as the VTP server. I would expect 3550/3750 (enhanced image) products can to the same. By extension I would presume this *should* work (but I've been around long enough to know it m...
You might need to upgrade your ROMMON. We did with our brand new Sup720's. Below is the procedure we use. Please pardon the formatting. If you see "invalid ..." after the "show rom slot n sp" you need to load ROMMON code (available from Cisco's downl...
Here's a difference ...You might find out that your Supervisor goes into ROMMON mode *only* after a power outage. Software reloads work fine. We've just discovered that to be a problem on several older Sup2/MSFC2's and we had same/similar issue with ...
