Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I recently took on a client who did not have any password information for his router and changes needed to be made. It's a Cisco 1720 on a T1 Frame Relay connection by the way using IOS ver 12.2I subsequently went through the password recovery proces...
I've got a location that will be installing a Sonicwall firewall behind a Cisco 1720. Currently there is a public IP on serial0.1 and a private IP on Fa0 with NAT enabled. We will be turning off NAT on the Router and using the Firewall to establish N...
I'm setting up a pix 501 to secure a VPN connection with our St. Louis office. Right out of the box I try and change the external IP addr. to a static one, okay but when I attempt to set the internal IP addr. so it fits within the parameters of our c...
Sorry for being so quick you are correct in that I am not able to access exec mode. You type enable then the password and nothing happens.There is a good possiblity that there was a previous enable secret password in place because I didn't use the no...
Sorry I'll try to be more clear. Console, Telnet and Aux all operate the same. I can only access user mode. When I stated that I used the enable secret password I wasn't being clear. I set the router to require password authentication on all external...
