Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
How do i set values for the following using SNMPfor a cisco 1100 AP.IpAddressGatewaySNMP CommunityHTTP,SNMP Enable/DisableSNMP Trap Destination AddressCan anyone point me the mib used for this
I have a cisco 1200 ap 13JA IOS version and i need to upgrade it to the next version.I am trying to upgrade through SNMP using the flash mib but it fails with InvalidSourceName errorThe entries i set in the mib areciscoFlashCopyCommand.1:-->copyToFla...
Hi, I am also facing a problem regarding the firmware upgrade of cisco1100 AP.The firmware tar file gets downloaded to the access point but is not extracted.But the diffrence is i am trying to do it through SNMP.The entries i set in the mib areciscoF...
Hi,The document contains only CLI commands to set the ipaddress,gateway e.t.c.. where i need to telnet to the device and issue an commandBut what i would like is to check whether there is any mib available to set the ipaddress of the IOS device byusi...
Yes..The Tftp server is running..The earlier problem i posted was due to flash memory not available.When i used copywith erase the tar file gets downloaded to the access point.But it is not decompressed and subsequent reset results in the Access poi...
