Help regarding cisco 1100 AP

[deepakuppuswamy]

How do i set values for the following using SNMP

for a cisco 1100 AP.

IpAddress

Gateway

SNMP Community

HTTP,SNMP Enable/Disable

SNMP Trap Destination Address

Can anyone point me the mib used for this

[wong34539]

This document seems to be talking about some the MIBs you are talking about,

http://www.cisco.com/en/US/products/hw/wireless/ps4570/products_installation_and_configuration_guide_chapter09186a0080101c39.html#1034719

[deepakuppuswamy]

Hi,

The document contains only CLI commands to set the ipaddress,gateway e.t.c.. where i need to telnet to the device and issue an command

But what i would like is to check whether there is any mib available to set the ipaddress of the IOS device by

using SNMP