Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
We currently have a functioning T1, just purchased a second T1 for the 3meg capability (was told by our rep that our current equipment will work).Question.1. Is it possible to combine the 2 T1 in the 1750?2. Can you help or give me some links to refr...
We have two sites one without any internet line just a frame relay that gets routed to the next site where we have internet line. Just got a 515e to do nat. Is it possible to do this with one physical connection at main site (the one with internet li...
First off I am new to Cisco.We have two sites, all traffic from site B gets routed to site A.(if site B wants internet all traffic comes to site A first). We have one entire class c and its divided into 2 subnets. We want to setup VPN between sites w...
Station_Router#sh runBuilding configuration...Current configuration : 1275 bytes!! Last configuration change at 02:42:26 edt Mon Nov 5 2007! NVRAM config last updated at 23:18:58 edt Sun Nov 4 2007!version 12.3service timestamps debug datetime msecse...
Thanks, I already looked at that, I guess I should have been more specific.When I try to enter the command "interface mfr mfr1" I am getting invalid command, I even tried "interface mfr1" same thing, I can however configure the subinterface. Its wire...
