Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I recently upgraded all my 1130 series APs to IOS v12.4(3g)JA and now whenever there is a power outage the APs randomly won't come back up when power is restored. I have to power cycle them once or twice for them to come back up. This never happene...
I have a AP1100 with a G radio that is giving me the following error:" %DOT11-3-POWERS_INVALID: Interface Dot11Radio0, no validpower levels available"from the web interface the radio settings are all messed up (see attachment) and it says it's a B ra...
I'm trying to get the number of clients associated to my 1200 APs which have dual A/G radios using SNMP. When I use the usual OID (the same one I use for my 1100 series APs) I get a constant 1 for the # of clients. I've tried many variations on thi...
Does anybody know of a way to reload the firmware on a Workgroup Bridge 350? Since there is no console port it's a little difficult to connect to it since the firmware isn't loading an IP address.Ben
tried that... from the Web GUI it won't let me shut down the interface... tried it from the CLI... it didn't have any affect. Then I had the bright idea of flashing the firmware to a different version... now it says:"Radio0-not installed" ... radio...
I had the same problem and contacted TAC for help. This is what they told me to do: (Use at your own Risk).-------Steps:1) Login to the concentrator through a console (or telnet) connection.2) Type "911" once you are logged in.3) This will require ...
I wouldn't think you'd have to install the ACU... in fact it shouldn't work at all with the ACU installed. Admittedly I only have 1100 & 350 APs, but they are all at the same IOS as your 1200s and they all work fine with 350 cards using IAS.
