Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Can a 5510 with active/passive failover do statefull failover for VPN tunnels? By that I mean do the SAs get passed to the standby unit so the tunnel would not go down when it fails over?
Hi Guys,I setup a linux server and am logging all my firewalls into it. The logging works just fine however when put a sniffer on that segment (where the syslog server is) I see all the logs being broadcasted. Do you know what is cuasing this and how...
yes, you can take out all pdm commands ... pdm or pix device manager (AKA pix device mangler) is to configure your pix through a gui interface. But I recommend not doing anything through pdm specially in 6.x code. You can take all pdm commands out an...
it'll cost you an iphone ... j/kis that 209.x.x.111 one of your public addresses?looks to me your are using the ip address of the outside interface that you obtained from DSL provider and trying to use it for your webserver. You can do that but you...
honestly i dont think you need two FWs to do what you want to do. I have couple of questions:1. How do you connect your inside 5520 to DMZ1 and DMZ2? 2. How do you connect the two FWs?
