Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
i have a pix 506e in our data center and a pix 501 in a remote office. they are connected together with a pix to pix vpn. can we limit the bandwidth available from the devices behind the 506 to upload to a device behind the 501 on port 5000 to less t...
We have a load balancing scenario with two RH 3.0 ES web servers behind an 11501. when we have nameservers listed on the rh servers when you try to ssh into them or open a web page the first connection take a while to get a response, but if the name ...
I am trying to configure a 3 router setup with frame relay, and i have run into a rather odd problem. I configured router 1 as the frame relay router (a 2514) to do frame-relay switching. interface Serial0 no ip address encapsulation frame-relay cloc...
we have a main office and two satellites, is it possible to segment each remote office into a CSR VLAN and an engineering VLAN and have them share the same interface back to the home office but not be able to see each other? They should be able to se...
Hi Robert-I think your problem is based upon how the CSC scans files. It is trying to get the whole file into memory before its evaluation. To bypass this you can go into the CSC and look at the deferred scanning settings...for example under http sca...
we have the groups with the appropriate services that are active...i think this is a name resolution issue, i take the dns off of the servers behind the CSS and they are able to run the route command like gangbusters, but if I add a public DNS server...
>where is your dns server located ?the dns server is outside the network>Is the firewall nating the server address ?>You should either nat on the firewall the server addresses or nat on the CSS from server to vip. the firewall is translating a public...
i am not sure about flash-load-helper... but i have just upgraded a half dozen 2500 series routers in the past few weeks...i think it is your bootstrap rom that is giving you problems, you should be using something more recent if you are trying to lo...
