Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
If the rotuer is ADSL( 826, 827, 836, 837) you can't configure priority-list and you will be configure CBWFQ.If the router is 805 put in interface serial0priority-list 1and before configure that you say "jolmo"Best Regards
Hi " ra jeshkalra";See this link--> http://www.cisco.com/en/US/partner/products/hw/switches/ps700/products_tech_note09186a00801d0808.shtmlCauses of FloodingThe very cause of flooding is that destination MAC address of the packet is not in the L2 forw...
Harald, try this: Fe0/0 -> for example IP LAN 10.0.1.254/24 Fe0/1 -> for example IP LAN 172.16.0.254/24Configuring DHCP in Cisco 2612 for FE0/0:ip dhcp excluded-address 10.0.1.X 10.0.1.X' ip dhcp excluded-address 10.0.1.Y 10.0.1.Y'!ip dhcp pool HERAL...
First, try to revise the IOS SOFTWARE, perhaps this IOS not permit configuring HSRP.If the IOS permit to configure HSRP try: Interface Fastethernet X/X no ip redirects Standby 1 preemt before to configure the standby ip XXXX.XXXX.XXXX.XXXXRegard...
