Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi,Is it possible to assign 2 or 3 IP addresses to PIX outside interface? (Just like secondery IP address in case of router FE port.) Is this feature available in new (7.0) os ?Regards,Sunil
Hi,We have 2 sites say A & B. These are connected by 2 routers each at every site. These sites are connected by 2 E1 links. We have EIGRP in place for routing.We found that only one link is being utilized. EIGRP doesn't seem to be load balancing the ...
Hi,We have done PAT for one VLAN. All the users (approx 50) in that VLAN accesses citrix port (1494) on the remote end server. Now few of the users can access citrix and load respective applications while the others are able to connect to the citrix ...
Hi,Can we assign 2 IP addresses to the same interface of any PIX firewall (Just like secondary interface on the router)? Is this feature available with 6.3(3) version? Regards,Sunil
Hi All,We have 2 2600 routers.One router has FE IP x.y.z.252 and the other router FE is x.y.z.253.When I try to put the first command for hsrp i.estandby 1 ip x.y.z.254, then following error it shows."address cannot equal interface IP address"Will an...
Thanks Raj.Is it advisable to use same PIX firewall for 2 different ISP's? (By configuring other available FE for 2nd ISP while outside interface for 1st ISP)Regards,Sunil
Hi,Thanks for your feedback.CEF is enabled globally.But I can't see 2 routes in show ip route.The scenario is as followsAt A site one L3 and 2 routers are in EIGRPAt B site one L3 and 2 routers are in EIGRPEIGRP on L3 at Arouter eigrp 110network 10.3...
