Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello,
Does anyone know how to force Cisco ASA to send GARP for NATed IPs? I'm using proxy arp and the ARP entries on the upstream device do not refresh after I change failover MAC address. The only way to fix this is to clear ARP on the upstream d...
Hello,
Does anyone know if the above device is able take and refresh ~500 GARP messages at once in one burst from a downstream device? I know that Juniper SRX1500 is having issue with that and many of the GARPs are being dropped and the table doesn...
Hello,
I have a situation where I need to bridge two subinterfaces into one L2 group. So any traffic can flow between TenGig0/2/0/2.602 and TenGig0/2/0/3.602 just as they were switchports.
Is that possible at all? Should I use BDI or something ...
The ASA responds to ARP for NATed IPs and that is correct and expected, but it seems that when I change the virtual MAC address of the ASA the GARP updates are not sent for NATed IPs.
It's not the intial ARP request that is the problem (that I can...
Thanks. I have other subinterfaces on TenGig0/2/0/2 and I only want to bridge one of them (.602) and leave other subinterfaces as they are. Does this syntax do it?
