Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi, I have set up GLBP on 2 routers I have in a test lab. One is a serial back to back running at 192k and the second is isdn2e running at 128k. The HSRP side of the operation ( i.e. failover etc )is working well but when I pass traffic over the inte...
Hi,Please review my attached .jpg for a more detailed explanation.I am trying to set up GLBP to load balance 2 routers, 1 serial link (GLBP weight 100) and 1 isdn link( GLBP weight 90) connected to the same router via differnent mediums.I am using os...
Hi,I am having problems upgrading the IOS on my 2600 router. My problem is :Currently I have a 2600 with 16mb on board SIMM memory and 32 Mb DRAM. I am looking to upgrade to the latest 12.3 IOS and have therefore bought and installed 32Mb of SIMM. Ho...
Hi,Please review the attached jpeg for a clearer understanding of my problem.Basically, I am using a Y-Splitter to split the signal from 1 Cisco CABX21MT cable in to 2 cabx21mt's. I am looking to connect these cable to the serial ports of 2 2600 rout...
Hi,I am currently in the process of implementing a network migration to MPLS and am looking to use HSRP. I have searched high and low looking for the appropriate cabling to split a DB15 connector from an NTU into 2 DB60 connectors to plug in to WIC-1...
Hi,I have used a syslog tool to confirmthe states of the f0/0 ports during normal transactions.When both routers are active the states are set to active ( for the lead router ) and Listen for the backup router, i.e. waiting for the lead router to fai...
Thanks to everyone for their suggestions so far but I am still having problems, my configs are below :Router A - Back-2-Back Serial running at 128kGLBP Priority - 100 (default)intf0/0 :glbp 1 ip 1.1.1.1glbp 1 preempt delay min 20glbp 1 weighting 100 ...
Thanks for that reply.I have checked and I have set both the serial router to run at only 64k and the isdn router to run at only 64k. They are however not load balancing.When I pass data the serial takes all the load until I fail this route at which ...
Hi,I have configured the serials using the clockrate command on the DCE end of the cables. Can you please explain how you use a primary and an internal.regardsRichard
