Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Currently we have multiple LAN segments/sites with only unicast routing enabled between them, mostly via DMVPN (GRE) tunnels on the router(s). Multicast routing is disabled on the routers, and local Layer 2 multicasting is used by a seperate 3com NB...
How does one add the custom graphics to the VPN Client?I'm using the Install Shield Install, because the .msi one looked too hard to customize with transforms and such.I have an oem.ini file, and I've changed the settings in that OK (like program nam...
How does one add the custom graphics to the VPN Client?I'm using the Install Shield Install, because the .msi one looked too hard to customize with transforms and such.I have an oem.ini file, and I've changed the settings in that OK (like program nam...
I am a little confused in trying to best configure bandwidth management for our Hub and Spoke DMVPN router network over the WAN. How would one configure a router to best handle traffic flow out a WAN link, where the router 'sees' the network as fast...
I wasn't sure where to ask this, but this seems the most relivent (sort of).Is there a document somewhere which details how IOS licensing works, along with how upgrades, etc work?I've looked around the cisco site, but can't seem to find any informati...
If you're still working on this one; iWAN 2.2 is starting to become available now.
If you've already come to a solution, may I ask what you came up with so far?
If I might hazard to jump into the "iWAN Supported" discussion a bit; I think it's import...
You said above you're stripping the 9 prefix in CUCM before sending to the gateway, but then you're trying to match 9 on inbound AND outbound dial peers on CUBE. You have to do one or the other. Since you say it's not matching the dial-peer 2 or 4,...
Have you read AT&T implementation guide?
http://www.cisco.com/c/dam/en/us/solutions/collateral/enterprise/interoperability-portal/flexible-reach-v2-isr.pdf
Lots of other CUCM/IOS versions as well in that interoperability portal (as well as lots of o...
I can confirm odd status behavior.Running Lync 2013 (15.0.4659.1001) with CuciLync 9.7.4 Build 716My Lync status doesn't change while I'm on a phone call but as soon as I hang up my status changes to Away. Thanks
