Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I have a 6 meg DSL circuit feeding an AP350 access point. Sitting next to the AP, I only get 3 megs of throughput. Any ideas why? AP is set to 11 mips, 128 bit wep, running V12.05. I'm less than 3 feet from it, so range is not the issue. Thanks,...
Periodically, I lose the ability to browse to any and all of my 340 and 350 AP's. They still work and pass traffic, but I can't get to them. I can ping them, they ping ok, just can't browse. Any idea why?
Hi Scott,The 3 feet is actually inside a water tower, well shielded solid metal. I can do this from any location, inside or out, and still see around 3 megs of throughput. I have all Cisco equipment, so compatibility is not the issue, but in fact, ...
Don't know. They are all located up inside water towers and such. I can reset power from the ground, but can't get up there to look. I have seen the LED's, they blink as normal, but I can't do much more than that due to the physical location.
Nope, can't browse via ethernet nor wireless. Tried that already. The only solution is to power off / on, and then I can browse. Telnet does not work either. I get the "Back = " and such, but can't get past that. All radios are running IOS 11.0...
Hi,No, I don't use dynamic DNS or IP, everything is static. It appears to happen when the AP's are heavily loaded, that is, many customers loading a lot of packets. I have DNS routing turned on and it's all specified there, and they are correct. A...
