Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi there, i need help!!!I have one-way voice problem between two cisco 3600 series equiped with NM2V and VIC-2BRI-S/T-TE, in both sides of voip connectivity and 2 alcatel pabx's; the first pabx is omniPCX 4400 and dhe other is 4200 E. On the 4200 Alc...
I puted evrth on both routers; but still the same situation; i've restarted bri's but the same. the 4200 site doesn't hear dial-tone and ringback when they call 4400 site. The DID is puted only in 4200 site and i've used "no digit-strip" command. If ...
i resolved the problem but i still not have dial tone and ringback on 4200 site. i've added direct-inward-dial, in 4200 site. But when i add direct-inward-dial in 4400 site, the situation is completly like before; i've used also no digit-strip comm...
voice port is present in original config (i missed it to write it) should i use direct-inward-dial??By your explanation, 1,2,3 are ok, and for my opinion follows:4- router connected to 4200 connects to router connected to 4400 and forwords 4 collecte...
no, cisco is configured as network in both sides;isdn bri config is:interface bri1/0 no ip address no ip route-cache no ip mroute-cache isdn switch-type basic-net3 isdn overlap-receiving isdn protocol-emulate network isdn layer1-emulate network isdn ...
