Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi Guys,
I am fairly new to cisco telepresence and trying to build a BoM for a customer. I have identified and chosen to use Cisco TelePresence MX300 55 Gen 2 (CTS-MX300-K9).
I need to confirm the following
1. Do I need a CUCM at the back-end?
2. Do...
Hi Guys,
When I try to launch KVM console from UCS manager, it asks for username, password and IP address.
I have seen an environment where this prompt does not come up, it just goes straight and launches the KVM. Also I am not sure what credentials...
Hi Guys,I am trying to open all ports between two LANs (LAN1= Inside, LAN2= DMZ) on my ASA firewall ..attached is my running config. What commands can I include to achieve this? Thanks for your help ..Richard
Hi Guys,I am new to cisco ASA firewall and need help configuring one ..I am trying to NAT 2 LAN IP addresses to Public IP addresses on ports 25 and 443.LAN IPPUBLIC IPPORT192.168.0.741.222.40.6225, 443192.168.0.841.222.40.3725, 443 Attached is a ...
Hi Pranay,So achieve my aim, I should run the following commands ..1) access-list acl-inside-outside line 1 permit ip 192.168.1.0 255.255.255.0 192.168.0.0 255.255.255.02) no global (dmz) 1 192.168.0.20-192.168.0.254 netmask 255.255.255.03) access-li...
