About katalin72

katalin72 · 03-16-2015

Hi guys,I have some HiPath PBXs connected in the network using a dedicated VLAN.While their uplink is a UTP port in any 2950 class Cisco switch, everything is working fine.When replacing the switch with a newer 2960 class. not working anymore.Moving ...

katalin72 · 02-16-2017

Hi, Unfortunately, no, still in the same situation. Just in case you'll find something, please share with me :) All the best, Catalin

katalin72 · 03-16-2015

and BTW... if I replace the PBX with a laptop with the same IP settings and connect in 2960, it is visible in the network, answering to ping. The PBX is not replying when connected in 2960, so I suppose could be some HiPath specific settings to see.....

katalin72 · 03-16-2015

Hi Andras, Just looked at them on the 2960 switch, but I can't make anything as being an issue. Pasted here below.On the old 2950, I can only see that interface is configured in the same vlan 15 - all that was shown - does not recognize "sh run all" ...

Member Since	‎03-16-2015 02:35 AM
Date Last Visited	‎06-27-2018 12:18 AM
Posts	4

User Statistics

User Activity

Siemens HiPath PBX not answering when connected in 2960 class switches

Hi,

and BTW... if I replace the

Hi Andras, Just looked at