Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I have a new 4507, running 12.2(20)EWA with Sup4s that is showing average CPU utilization between 6-10%, with no line cards or devices plugged in. The processes seem to be Cat4K Mgmt HiPri and LoPri.Does anyone know if this is normal? I am concerned ...
I have a switch running Version 11.2(8)SA3. I want to configure dynamic VLAN assignment using VMPS. Does anyone know if this old switch supports this functionality? The docs I found say the 2912 and 2914 do not, but do not mention the 1916Thanks
We are looking for high-availability solutions across our WAN. Has anyone implemented a wide area load balancing solution using the Cisco Distributed Director or similar product, such as F5 3DNS?These products use probes or other monitoring to determ...
Anyone know if it is possible to perform NAT on a tunnel interface without using IPSEC? I am trying to do the following:int e0IP nat insideint tunnel0IP nat outsideAny help or ideas will be appreciated.
It sounds like some device between the switch and the internet does not have a route to your inside address. The internal network addresses need to be:Internet routableorNetwork Address Translated to an Internet-routable address spaceorYour address i...
If the tunnel works for about 10 seconds, and then goes down, it is probably an incorrect eigrp network statement. Be vary careful which networks you advertise.
