Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
i have a cisco AIR-LAP1262N-A-K9 that i am trying to convert to Autonomous.
i do not have the passwords,
i have done the factory defaults but the default user name and password do not work.
boot into setup mode by holding down the mode button...
thanks for that info.
everything worked expect the last command.
but loaded anyway.
another problem i have ran into is that the tftpd64 software only runs one time.
i reboot the computer it works fine the first time, loads firmware into ap, but...
