Dear Folks,
I have ASA 5545-X firewall. I have added nat rules in the ASA thru ASDM, it is not allowing more the than 9 rules.
9 rules are effective and after the 9 it is showing no numbering. Snap attached.
Regards,
Ashish.
Hello Folks,
Need your help to understand the licensing of Cisco ASA5545 FirePOWER IPS.
I have 2 ASA 5545-X with FirePOWER Services, out of the box I have received the ASA 5545-X with FirePOWER Services (ASA5545-CTRL-LIC) on paper.
I have installed...
Hey Folks,
Looking for help...
I have 2 ASR 1001X routers for WAN connectivity for Data Center. In this scenario, ISP is giving a single WAN connection (x.x.x.x/30) with 2 physical links.
Now I have 2 physical connections but only 1 IP at my end....
Hi Folks,
I have a pair of ASA 5545-X. When I check the license details, it shows Failover-Active/Active.
Can I use firewall in Active/Passive mode?
Regards,
Ashish
Hi Folks,
I am going through a problem with connectivity between our server and NetApp storage.
Server is writing data on storage drive. Common connectivity is normal between these but when application team is storing the data on storage disk it tak...
Thank you for quick response.
I m getting "FireSIGHT license required." message for many of the features of Firesight, like Network Discovery, Network Map, OS fingerprinting etc.
It would be great if you can brief me on that .
Regards,
Ashish.
Thank You Rechard,
These two links are connected to Gig port of ASR routers, i don't have serial link.
The basic requirement of customer is to have router level redundancy if one ASR fails another to take over in host standby.
Regards,
Ashish.