Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi all, tried searching but am unable to find an answer specific to my issue.I'm testing some equipment at the moment, the basic setup is tester software on laptop connecting through the on-board ethernet NIC to our DUT. Some data needs to pass throu...
In this case would the switch be smart enough to tag data going back out on that port, on egress? I presume either this happens or I would apply a tag to the second device port.I'm unable to test this at the moment due to licencing issues with our te...
Yes that's exactly what I want. I suppose I effectively want to emulate a remote site with QinQ tagged data arriving and the service level tag removed before being switched to other devices.
Hi Aleksandra,Thank you for your response. I've tried using QinQ settings by putting the device in QinQ mode by configuring port 10 as a customer interface. I then assigned port 9 as an access port (untagged by default) on the same VLAN (100), but th...
