Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
class-map type control subscriber match-any DSLAM-TEST match protocol ppp dhcpv6 end-class-map
!
policy-map type control subscriber DSLAM-TEST event session-activate match-first class type control subscriber DSLAM-TEST do-until-failure 1 authenticat...
Is routed subscriber session DHCPv6 supported? I want to point DHCPv6-PD and regular DHCPv6 requests from a downstream aggregation router to the BNG and have the BNG allocate prefixes/addresses to the clients. Is this possible?
Hello,
We are deploying AutoInstall for config file push and image file upgrade. This is working great. However, in the case where we have switches that have full disk space the image file upgrade does not work. The normal upgrade process for us is b...
Hello, we are deploying SG300s in a very expedited, rapid manner. The goal is to have a technician take out an SG300 from a warehouse and have the SG300s auto-upgrade their firmware and download a base config on start-up. The purpose for this is to r...
Hello, is there any way with either IOS or IOS-XR (route policy language) to suppress an aggregate with BGP? For instance if I receive a longer prefix that's part of an aggregate with a certain tag or community, is there a way to tell BGP "don't adve...
Do you know if it is possible to define different DHCPv6 pools per-VRF in the BNG or would I have to define this with a RADIUS VSA? I currently have pools defined under dynamic-template but these are in default VRF and do not allocate to subscribers ...
Hello Xander,
Is it possible to do dual stack PPPoE with IPv4 in a VRF and IPv6 in default table? I am testing with the following VSAs:
ip:vrf-id=TEST
ipv4:ipv4-unnumbered=loopback09
When I don't pass the VSA, I get an IPv4 and IPv6 subscriber rou...
The VRF setup should be transparent to each router. They should simply see each session as an eBGP session to a different AS.
Can you show your BGP config "sh run router bgp" from each side?
Is routed subscriber session DHCPv6 supported? I want to point DHCPv6-PD and regular DHCPv6 requests from a downstream aggregation router to the BNG and have the BNG allocate prefixes/addresses to the clients. Is this possible?
I believe it is becau...
