We have a Cisco SG350-28P 28-Port Gigabit PoE Managed Switch on a Customer Site witch have to provide Power over Ethernet to the Desk Phones (Series 8800). The normal phones (8851) are working as expected. But the Phones with the digital Key Expansio...
Hello,
i have tried to downgrade the software on that switch. With Version 2.2 the problem still exists. After the Downgrade to 2.1 the switch didn't boot up again. Now the System stuck in a boot loop. With the console i see following error:
%HAL...
The Switchport is running with following power setting:
Entry No.PortAdministrativeStatusOperationalStatusTime RangePriority LevelAdministrative PowerAllocation (mW)Force Four PairPowerConsumption (mW)ClassPoE StandardNameState6GE6EnabledDeliverin...
