Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I have 8 no. AIR-LAP1131AG-A-K9 and WLC 2112 Wireless LAN Controller,i configured the device and its working at deffent SSIDs but when i am trying to enable same SSID on all LAP it shows "AP on dupplicate SSID found and Layer 2 security found".
when i reset the device it is open in by default ip in GUI but when i configure the device after that when i enter save and reboot command it is not open with new ip in gui.
Dear,I have purchased 10 no. of cisco AIR-LAP1131AG-A-K9 and 1 no. of cisco 2112 wireless lan controller. I have configured the controller and connect the LAP to the controller but it's not joinning to the controller.So what should i do???
Dear,I have configured like this by command prompt....Management Interface IP - 192.168.1.2,Subnet - 255.255.255.0, Gateway -192.168.1.1, Port - 1,Vlan - 0 (untagged)AP Manager IP Address - 192.168.1.3, Subnet - 255.255.255.0, Gateway -192.168.1.1, P...
