Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello,I just installed LMS3.2 and I have to configure it to monitor my network (4 routers and 30 switches).I am looking for documentation especially for the IPM part.thank you for your help.
Hello guys,i have on network issue on my Cisco881.i must configure a FailOver using a MainLine SPI1-PublicAdd_1 and a backup line SP2-PubliAdd_2. i don't know if it possible to "build" twu Tunnels reaching the same Adresse on the ASA. here attached ...
Hi Rizwan,thank you for your response.I just want tell you thant in can configure only my side (The cisco881). the ASA is configured by another personne.i attached my shared configuration here up. can you open it and telle me what goes wrong. Please...
youre right. 0.0.0.0 0.0.0.0 is enough. i just added iti have not yet tested individually DSL..I ll telle you when did.but what do you think about the rest of the configuration ..specially the interfaces ??
Hi Rizwan.Here are the configuration to which I arrived. Once I have the definitve WAN IP address, I will put the IP SLA that you gave me.but if you can look and tell me if there are errors.I remind you that I will connect the router to two Box that...
