Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I have seen this interface configuration around on a few switches in my network.interface GigabitEthernet1/0/10 switchport access vlan 2 srr-queue bandwidth shape 0 0 0 0 What would the srr-queue command do here? there is nothing else on the interf...
I'm having a problem with the output queue on the 3750.I’m marking some SNMP traffic with CS2 (DSCP16)I’m using the default queue-set on the egress interface and the priority queue is not enabled. There are lots of output drops from this interface an...
I have this ACL applied to a VLAN interface as follows:ip access-list extended catch-snmp permit icmp host 10.83.1.13 host 192.168.60.172 permit ip host 10.83.1.13 host 192.168.60.172 permit udp host 10.83.1.13 eq snmp host 192.168.60.172 permit ip a...
Is it possible to have a switch, outside of an MST region, running PVST that is the root switch for some VLANs?We have a L2 link to an ISP, the ISP has set their switch to STP priority 0 for all VLANs, so it is the root switch of our network and is c...
Hi have a little 877 router running Version 12.4(24)T2. I want to muck around with an IKEv2 IPSec VPN but i can't find anywhere to configure IKEv2.I have found some doco that says its under the crypto config, something like router(config)# crypto ik...
Thanks that looks to have fixed the issue.Can you please explain the number you assigned with the command"mls qos queue-set output 2 threshold 3 3100 3100 100 3200"I understand that the maximum number is 3200, does this mean it is possible to starve ...
While i understand the bufferers issue, i think something has changed in recent IOS. I have a simialar blade running an earlier version of IOS 12.2(22) and i don't see this issue. Same goes for some 3750s i have around as well.Anyway - it does look...
hi Eugene1) Yes output drops are incrementing all the time. This happens on every active interface but i will just focus on Gi1/0/12)AUADFLEES100#show controllers ethernet-controller gi1/0/1Load for five secs: 13%/0%; one minute: 11%; five minutes: ...
