Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi group,
anyone has experience with the install all no-reload option on nx-OS ?
Is it correct that the image is extracted and saved without the disruptive reboot ? I would like to use it to prepare all my switches with new software and then reboot ...
Hi
Group any idea how this could happen in zone based firewall:
sh policy-map type inspect zone-pair sessions
Zone-pair: Guest->Internet Service-policy inspect : Guest_to_Internet
Class-map: Guest_Protocols (match-any) Match: protocol http Match: pr...
Hi
I'm trying to send attribute 30(called station) in my radius accounting session. This is working fine for attribute 31 (calling-station).
I have the command "radius-server attribute 30 original-called-number" in my configuration.
Any idea wha...
Hello
I'm trying to forward a radius attribute (cisco-ip-pool-definition) from an external identity source to my CISCO ASA vpn device.
I can see in the TCP Dump that the attribute is received from my external Radius server,
but I am not able to cr...
Until now I was doing MAC authentication for my autonomous access point on the cisco ACS. Now I'm trying to create a policy on the ISE to do the same. However I am not able to create a compound condition to match this MAC authentication request.
For ...
I have done the upgrades: with the no reload option you save time: the compatibility check is done + the new image is set as bootimage. It does save some time but if for some reason you lose power the switch will reboot with the new image (which cou...
Does anyone know if there is a way to activate the scheduler when doing a config save ? With the archive feature you have this option (but archive doesn't support scp)
Thx
