Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
HiDont think this is possible but will check, currently running Cisco Firepower 6.4.0 I know you can publish a website via NAT, but doing it this way needs a unique external IP for each site. What if for example you only have one public IP but need ...
Having an issue that so far I cant figure out. My actual issue was that I was trying to allow a site that was blocked by another rule, but I went back to basics and try to get a basic URL rule to match in the logs. Using Cisco FirePower version 6.2...
Hi Allusing Cisco FirePower and created a rule to allow web traffic on 80 and 443, can see traffic hitting this rule in the logs this is fine. But, we are using "Inherit from base policy (Balanced Security....) so lets say we visit a URL on port 678 ...
Hi All,
We are using Configure Cisco Firepower User Agent for Active Directory installed on a domain controller, both sections are green which seems to indicate it should pass the details back to the firepower.
I have some rules on the firepower an...
Hi Everyone,We have lots of numbers come in on our SIP, we are have problems with just one number that during busy periods (intermitant) generagtes a ISDN Code 57 and 403 Forbidden error in the logs, like all our numbers this points to a Cisco CCX sc...
Thanks for that link Abheesh Kumar I will need to spend some time today and tomorrow looking at that, I have found a few other similar posts so will take a look and see what is found. In the mean time if anyone has any other suggestions please let ...
Hi
Thanks for the reply, essentially that is what I have done. I have the correct IP in the logs, but no usernames appear in the logs. It just shows as BLOCK in logs but no username details as soon as I remove the username from the rule, it works.
...
