Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello
Due to shortage of public addresses we would like to take advantage of inbound NAT (from internet to the internal network) using the public interface of the ASA, is that possible for the following topology? If so please also provide configurat...
Hi All I have a 2600 router with two LAN interfaces which I am using for a PoC and has the following settings:FE 0/0 - 10.0.0.1/24 - client LAN - inside FE 0/1 - 10.1.1.1/24 - server LAN - outside The direction of the flows are from the clients to t...
We are using ASA 5510 with 8.2(5) and trying to have a L2L session with Strongswan at the other side.We get phase 1 established but ASA rejects phase 2 due to crypto match policy not found. We expect them to hide under their public address and whene...
1 - Can the same vlan be used in more than one context?2 - Can you configure one arm and two arm loadbalancing within the same context? Thank You Darius.Fariborz@CGI.COM
Hi There Sorry been out of the office recently. We managed to get the configuration working by introducing a 2nd router. Network diagram is attached for your consideration. Cheers Darius.Fariborz@cgi.com
Hello Please find attached the network diagram of my tests. The results that I got for using "ip nat inside source static ip 10.1.1.100 10.1.1.10" was as before i.e.ping to 10.1.1.10 - workedping to 10.1.1.100 - didn't workTCP to 10.1.1.10 - didn't w...
HelloI tried your suggested config but it didn't work. The results were as follows from 10.0.0.100:ping to 10.1.1.10 - workedping to 10.1.1.100 - didn't workTCP to 10.1.1.10 - didn't workTCP to 10.1.1.100 - workedThe reason for this is that a legacy ...
