Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi, I just got these messages, and I couldn´t figure out what that means. 004 Dec 08 13:49:08 MEZ +01:00 %SYS-2-MOD_INBANDNORESPONSE:Module 2 (Standby) not responding over inband2004 Dec 08 13:49:08 MEZ +01:00 %SYS-2-MOD_INBANDRATE:Module 1 inband ra...
Hi, I would like to know if there is anything like "clear conf <slot> " for Catalyst 4500 with a regular IOS 12.1.13EW.I know it works fine with the CatOS.I would like to clear the configuration on a specific slot, that used to have another module, s...
In the last months I had problems with the Modul type WS-X6348.I had at least 3 moduls in different Switches 6509, which all had experienced a couple of reloads in the last months. The show log counters is up to let´s say 21, and this is not a "count...
My Question:During a remote upgrade of a cisco 2500 I "discovered" the boot flash helper.How does the boot flash helper in a cisco 2500 work ?I could´t find any good material on the CCO.Especially how does a static route become the Gateway of Last Re...
hi I just installed a AS 2511 at the other end of the City, and I accidentially forgot to write down the serial - number alias device ID. Now I can only get the processor ID, but this is different to the serial number, as you know.Is there a workar...
Hi, sorry I haven´t seen your posting. Ok, I can´t mess around , because it is a live system. I know it would be easy with the standby , but right now we are not allowed to change anything, unless it´s dead or we have an outage.It´s running the cat60...
I think the CCNA Study guide by Todd Lammle gives you more than a good understanding what you need to know.Afterwards I did the Boson test for CCNA, .. and if you understand the questions and make it up 90 percent, the actual CCNA Test will be "easy"...
Sorry, the explanation at this link is fairly poor. I have a Cat4500 with IOS, and without the "ip host-routing" the device doesn´t even respond to a ping.Is there any other paper that goes more into details ?Thank youYves
