Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Does a complex gateway (IGX/ BPX) the check of AAL5 CRC in both directions, andif yes, how the errors shows up (e.g complex gateway errors)?Question aims on a Frame-relay connection which runs over a ATM Backbone.FR--> Fastpakets --> complex Gateway ...
HI,you should check if the interface is really working in full-duplex mode withthe "show interfaces ..." command. I have had once the problem that, eventhe interface was configured to use full-duplex, it runs in half-duplex mode.Under normal conditio...
Hi,you must analyse the X.25 traffic (maybe with an analyser) and check for the reset cause, which is included in the reset message. This will give you a hintwere the problem comes from.regardsUlrich Marzoliwww.netaid.de
Hi,IMA stands for (inverse multiplexing over ATM) so the interfaces can onlytalk ATM. Therefore your customer need to connect to an ATM Interfaceon the opposite site.Because the customer has already 4 locations connected to Frame Relayhe should eithe...
Hello,you can't connect a T1 (Frame-Relay) card to a ATM-IMA card (using PIN 1,2,4,5). If you want to simulate this, you must use a router (ATM and FR) inthe middle who will translate between FR and ATM.In a Cisco powered FR/ATM WAN the protocol tran...
Hi,no the bandwith parameter is only used for the routing metric calculation andthe calculation for the reserved bandwitdh for the EIGRP or OSPF routingprotocols and has nothing to do with the link protocol wich is not runningcorrect.Check the interf...
