Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
HI,Just would like to know the supportability of PPP Network Control Protocol for MPLS(MPLSCP/TAG CP) in Cisco?When another vendor sends MPLSCP Conf-request in PPP , Cisco side is dropping this message with the following debug message displayed:> ...
Hi, Does cisco support mpls over atm-ppp-llc per RFC 2354(PPP over AAL5). Something like a scenario if Cisco acts as a PE and it gets frames with mpls over atm-ppp-llc from a connected CE ,is it supported in cisco , or it will drop the frames ? Runni...
Hi,Does cisco support mpls over atm-ppp-llcper RFC 2354(PPP over AAL5).Something like a scenario if Cisco acts as a PE and it gets frames with mpls over atm-ppp-llc from a connected CE ,is it supported in cisco , or it will drop the frames ?Thanks i...
Is FRF.15 implemented/supported by Cisco.Also whether the implementation depends on platforms , ie: is it supported on a 2800?If yes ,would be great to provide a url on config/debug details.Or a different terminology is used ?
hi peter ,Thanks for your response..yes..its reqd for the scenario where we need to take mpls directly to the CE.Also I have a basic question abt the product,pls forgive my ignorance .Can a 3640 can have PE functionality?Or only higher end Cisco rou...
Hi Swaroop,Thanks for your reply..I think you are mentioning about NHLFE ,here in your first reply... I have two more queries.. Pls refer the below diagram.. Vrf1a..Router A ---B ---C--Vrf1d I am running targetted LDP between the lo A and Loopback C....
Hi Rick,thanks for your reply..<<>>So if there are 2 equal cost paths ,the first ICMP TTL1 goes thru the first path ,second ICMP TTL2 thru the second path ,third ICMP TTL3,thru the first path and so on..?is this what you meant or whether I got you wr...
Hi,Also ,in other words,the 4 bytes is the MPLS header size ,in which label size is only 20 bits .Why with each addition of a label we are adding 4 bytes of the header ,rather than just 20 bits.Hope my question is clear .Thanks in advanceThomas.
