Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
HelloI have two Cisco FPR 4110 with FTD version 6.7My problem is Memory used by snort even when there is no many traffic on firepower .my configuration in the firepower are IPS with recommendation enabled and SSL Policy for traffic incoming from out...
HelloI have Collapse Core Network and My Core Switch is 6500 . The Core handling Inter VLAN Routing and it is gateway for my clients . in the next hop after Core Switch i have ASA 5525X . and every things is OKwhen replace ASA with FPR4110 all of thi...
Hello everybodyI would like to Cisco ISE HA with Smart License. Two Cisco ISE with one is Primary PAN and other Secondary Our Company have 1000 users with one session for any userHow many Base Smart License are required ?
I would like to deploy ISE Posture with Cisco Any connect for our Company with 2000 UsersHow Can i Install and deploy ISE Posture Profile to all Users in our Company . What is Solution for this situation ?
Hello to everyone I have a FTD 2110 and when after restore a backup either with FMC or SCP Server .FTD mark as offline in FMC .when ssh to FTD all of configuration is restored and that is OK .I cannot find any solution for this problem
But what is different between Cisco ASA and FTD in DHCP Snooping Options and Packet ?when ASA is the next hop of Core Switch all of thing about DHCP and IP address obtaining are OKwhen replaced with FTD 4110 i cannot seen DHCP requested from Source I...
Our Clients are in different subnets and Core Switch (6500) is the gateway of our clientsand all of config related to "IP helper " under Core Switch interface is done .this scenario is OK with ASA and all of DHCP traffic are allowed in ASA .when repl...
Hello MikeMy question is i have two ISE and do i need two base smart license for each ISE ?in the Cisco CCW when i choice base license for ISE, in the first step must choice number and then select part number
the reason is when delete FTD from FMC and re added to it , Routing on FTD removed .restore backup to FTD for routing come back to FTD my FTD have OSPF routing to Core switch . when delete and re add to FMC . all of routing is removed .what is mean ...
