Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi, i have a 2802i running MobilityExpress 8.10.162.0 as primary controller and prefered master (AP1). I successfully added a 2702i as subordinate AP (AP2). So far everything looks good, I have no errors. But the AP2 keeps blinking red green althoug...
I was able to reset the config of AP2 through the controller, but no success. But now I found this: https://content.cisco.com/chapter.sjs?uri=/searchable/chapter/c/en/us/td/docs/wireless/controller/technotes/8-0/AP_Regulatory_Domain_DG/b_universal_AP...
Hi marce1000, at the moment there is no other device connected to this switch. Power consumption is 6.8W (AP2) from available 130W. The AP was before used as autonomous AP. I converted it to LWAP and did a factory reset via mode button. Is it possib...
