Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I have setup NTP on our network with our core router as master. Can the PIX be a NTP client? Is so, where is the command reference? If not, how do you sync the time the on the firewall to match the network?Thanks for any help!
On our switch between the outer router and the firewall I want to put an intrusion detection device. Can I use a switch or must I use a hub to see all of the traffic?
The event logs show the two Aironets associating every 30 seconds. This an INFO message but is this normal to do it so often? We have seen some degrading of the network response over the Aironet and we are looking for possible things to check.Thank...
No, I don't think it can. It was not until 6.1 that it could act as a client. The following link talks about the client.http://www.cisco.com/univercd/cc/td/doc/product/iaabu/pix/pix_62/cmdref/mr.htm#1033398
