Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Is it possible to set a maximum call duration for a dialer interface? I'm not thinking of idle time. My customer wants all calls on a particular dialer to last no more than 60 mins regardless of traffic
Hi, I have a Cisco 801 router at one end and a PIX 506 at the other. VPN from 800 to PIX is OK However a PC connected to the router will work with no probs for (almost exactly) 15 mins. It will then have to wait for the line on the router to drop, ...
Hi, central site has a PIX 506 and the remote sides are a mix of PIX to broadband, router to ISDN and Dial-up clients. Customer cannot get static IP at each of the router (ISDN) sites, therefore I need to make the link to the central site with dynam...
Thanks for the response, but having played with it a lot I have got it working without static nat. I believe that you are absouloutely correct in what you say, but if you make the router and the PIX the two end points and then by-pass NAT for IPsec ...
I have the same errors with a 3.x Client behind a Cisco router running NAT to the Internet. It has to be something to do with the NAT on the router because if I connect the laptop to the Internet via dial-up the exact same config works OK. I could ...
