Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi,It is required to integrate CW LMS with crystal reports. Can anybody tell me what is the procedure fro this. I have installed the Crystal reports and the server is recognising the ani.db & rme.db in the same server. While trying to connect it does...
Hi,There is a requirement for connecting Cisco 2600 to Nortel ASN over ISDN PRI. Has anybody worked on this setup? If you can give me some input on the configuration at the ASN side, I'll be grateful.Regards,Naveen
Hi,The customer uses the IP Telephony for the WAN locations (within the country and abroad). Is it possible to get a report in which the billing (Rate) for the abroad location call is diffrent from that for the local locations?Thanks Naveen
Hi,I'm facing a peculiar problem. The network is working fine when the CCM and all the ip phones are functioning.But if some identified phones are switched off, the entire LAN hangs and I'm not even able to login to the switch (3Com). During the pro...
Hi,What is the min bandwidth required per call using any given codec (G729) over WAN, with QOS implemented. How can the BW taken for a call over the WAN be measured without using any tools..?Thanks in advance,Nav
u can refer the following URL for information regarding multiflex cards.http://www.cisco.com/en/US/products/hw/routers/ps259/products_data_sheet09186a0080091b9c.htmlCheers,Naveen
Hi Sanjay,You need to configure the CE1 controller first. It looks like,Controller E1 Slot/modChannel-group 0 timeslot 1Channel-group 1 timeslot 2.........................................channel-group 30 timeslot 31After this configuration, in the sh...
Hi,Thanks for the reply..Regarding the second qn I raised,By saying "without using any tool" I mean without using any traffic analysis tool.Is there any way of measuring the BW used by a call, at router/CCM ?My intension is to get the BW value for a ...
