Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi,After upgradeing from 3.2 to 3.3 we are facing the following problem:when using external db authentication, where "the unknown user policy" is set to "fail the attempt" no more authentication is possible and the acs server reports "CS user unknown...
Hi,We want to authenticate RAS users using LDAP queries on a Windows 2000 AD. We also setup a unknown user policy authenticating users using LDAP.With this configuration we are running in the problem, that all users defined in the LDAP can access our...
We have the same problem, but get no replyTake a look athttp://forums.cisco.com/eforum/servlet/NetProf?page=netprof&CommCmd=MB%3Fcmd%3Ddisplay_location%26location%3D.1dd666c4CheersMichael
Below a solution taken from jason:I hace found that it is best to start out with a clean install of the the backup server. The steps below assume you are using a primary/seconard approach. Once it is setup all changes should be made on the primary th...
I'm a little bit confused about your problem:When adding a new aaa client you can define the authencation method, in your case RADIUS (Cisco Aironet) or RADIUS (IETF).In the interface configuration you will find a new entry displaying RADIUS (IETF), ...
