I have one ISDN PRI line, and want to assign peer ip address based on authenticated username. On the other hand I mean I have some ip address pools belong to different department. Everyone who dial in the company may obtain the ip from his department...
I used some C2950G-24-EI and C2950G-48-EI, and I installed the cat2950 device package 3.0.Now I encount the problem that I can see the c2950-24 in campus manager, but campus manager treat the c2950-48 as "ciscoproducts.429" device.The other problem i...
The router is 1721 with ADSL wic, the version is 12.2(11).I have done pppoe client on interface atm, and the ADSL line is up. I can ping internet from the router. Then I want to do NAT overload for local users. I use command " ip nat inside source li...
The 3550 IOS version is 12.1(6)EA1. I use help-address to forward DHCP request. But it cant work. When I debug ip udp, I can see 3550 forward udp 139 to help-address, but not forward udp 67,68.
I have no Cisco ACS 3.0. I tried Microsoft IAS, but seems it doesn't support EAP. Can I do dot1x using EAP local authentication? If can, how to configure it?Thanks a lot.
Thank you for your response.I have some related questions. Can I use radius server ( eg. MS IAS) to do that? And if I use acs to assign ip address, what command can I use to intead of "peer default ip address pool LOCAL_POOL".
I have done it. But it can not resolve the problem. And I think it may be NAT problem, ping packet will not increase its size, I can ping successful first packet, the sequence are failure.
My IOS version is 12.2(8)T.I tried to use "aaa accounting delay-start", but I can't see the source ip address of the PPTP tunnel. My radius server is Microsoft IAS, should I use ACS instead of it ?