Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Then why can't it pass internet traffic!!! Long story, short I had the Pix running its basic nat/global "I pass all traffic from inside to outside" config running without any problem. Well I did have a bit of a hard time actually getting the traffi...
Yesterday everything was fine. The only thing I was messing with was setting up a LAN to LAN connection between a Pix and the 3005, and there weren't any problems with that as far as I could tell, and plus I have deleted any entries I have made which...
We have an issue where if our central site VPN concentrator goes down then all of our remote sites can't access the internet. I just want to know if this is another built in "feature" of the 3002 Hardware Client, and if it isn't then what do we need...
The Setup: We have a 3005 Concentrator at the central sites and multiple 3002 Clients working in network extension mode. If you are at the central site you cannot access the networks behind the 3002 until some one from that side "pings" a central...
All the phones use power bricks.The majority of the phones have Dell PC's plugged into the PC port. We used the switches to see if it was just the Dell PC's that caused the phones to reboot or if it was the link itself. You can plug a switch into t...
Hello, I'm an engineer with the saem company working on the problem and here's the progress so far.We've run both 6.0.3 and 6.0.4 loads on our 7940 and 7960 phones and the problem still occurs.The specific problem is that when the phones PC port come...
I set it up LAN 2 LAN. Have a network list in the source field on the 3005 of 172.16.y.0 and that 10.z.0.0 network. I'm having it shipped back to me so I can hit it with a hammer and upgrade it to version 6.2. I'll let you know if it solves anythi...
Yes to all of the above. I can see the connections in sh conn, and I can see the translations in sh xlate. The log show the connections being setup and torn down, but nothing is shown coming in. And it still blows my mind that I am passing IPSEC t...
I use a "router on a stick" setup. Dusted off some old Cisco router that I found in a closet one day, and setup the router to send all 0.0.0.0 to the PIX and all remote VPN site traffic to the concentrator. I then setup all of my workstations to us...
