Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
i have 2 bldgs connected with a layer 2 8mb link, plugging into a 100mb port of a 3560 at each end. I would like to shape outbound traffic to 8m and make sure voice gets transmitted in priority queue. with llc, only occures when 100mb port is conge...
whey I apply qos settings to the hardware queues in say a 3650 or 6500, are they used all the time, i.e is voice always sent first in the priority queue or is it only when port is congested like in llc or cbwfq?
ok, I may be missing something simple, but I have 2 3550's no ip routes, no default gateway set, no dns servers set, yet I can ping outside addresses, traceroute to them and resolve names miraculously, any ideas where these default routes might be co...
glbp 1 weighting 110 lower 95 upper 105glbp 1 weighting track 10 decrement 5I understand that the weighting of my avf is 110, i also understand that when interface being tracked by id 10 goes down my weight is dropped by 5. So when I hit the upper 1...
im not really sure why it works on the 3560 as it shouldn't. the only way for multicast to reach from one vlan to another would be to route, just like normal traffic. Therefore, you would have to turn on multicast routing, create a routing interfac...
i understand that, but does shared round robin take effect even if the port is not congested, say its a 100mb port and only 30mb used or in proper terminology, the tranmit ring isn't full, does the priority queue still get serviced first.
