Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
The following router is running ATM IMA. There are four t1's connected but only two used. The fourth t1 is shut down administratively. ATM1/1 is the second t1 not being used however it was not shut down admin. This morning bgp was flapping and te...
I have two 2600 routers back to back with a cross over cable between them. If I pull out the plug on one end I lose line protocol on the other. If I try this the opposite test the second router does not lose line protocol. Both routers have keepal...
Currently I have a 2620 router in Johannesburb with two low speed serial interface cards. There is a E1 circuit connected to S0/0. We are running a Frame Relay point to point. The CIR/EIR values are 768/768. However even when running well below t...
There is a bunch of ways to do it but this should work.no ip access-list extended Policy-NAT!ip access-list extended Policy-Nat no permit ip host 10.1.0.11 192.0.0.0 0.0.255.255.255 permit ip host 10.1.1.11 192.168.2.0 0.0.0.255end!
Using a layer three switch with an internal route switch module can be used for inter-VLAN routing. The allows the switch to route one switch many and take advantage of the speed of the switching fabric which is much faster than the router. Steve
Mark,ATM1/1 has not been bouncing. Also, there are no erros on the ATM interfaces. However, BGP was flapping. Our Engineers have a TAC case open looking for a bug in the IOS. However, I feel like the problem is somehow with the third t1 being plu...
