About szeshiong.lee

szeshiong.lee · 07-17-2002

Hi All,Symptom: A few Cisco Catalyst 2950 switches installed into an existing network. All users migrated to the new switches. Most users have no problems with connecting to the "new" network. However, users using 3C905B-TX NICs do not have network c...

szeshiong.lee · 07-18-2002

Hi,There are 2 ways to allow a Cisco Catalyst 2950 Switch to own an IP address so that it can be pinged by hosts on the network. First, you may try to run the command 'setup' in Priviledged EXEC mode and follow the instructions of the setup program t...

szeshiong.lee · 07-18-2002

I did not change anything from the default settings. I'm assuming that the default does not have any port security settings enabled.

szeshiong.lee · 07-18-2002

Hi,The interfaces are up. There are no errors. And the only VLAN I have is the default VLAN1. No other VLANs are configured.The switches that I'm using are new, and I am experiencing this problem with default settings that came with the switch.Regard...

szeshiong.lee · 07-18-2002

Hi Colin,Thanks for your valid suggestions. I think the cabling should not be the source of the problem as I'm using newly installed Cat 5e cables. However, I do have to admit that all this time I was trying to set the speed to 100Mbps Full Duplex an...

szeshiong.lee · 07-17-2002

Yes, I did. The switch port and NICs were manually configured to run at 100Mbps, Full Duplex. However, that did not help with the situation.Thanks

Member Since	‎07-17-2002 07:12 AM
Date Last Visited	‎08-18-2017 03:51 AM
Posts	6

User Statistics

User Activity

3Com 3C905B-TX NICs cannot connect to Cisco Catalyst 2950 Switches

Re: Config problem with Catalyst 2950 series

Re: 3Com 3C905B-TX NICs cannot connect to Cisco Catalyst 2950 Sw

Re: 3Com 3C905B-TX NICs cannot connect to Cisco Catalyst 2950 Sw

Re: 3Com 3C905B-TX NICs cannot connect to Cisco Catalyst 2950 Sw

Re: 3Com 3C905B-TX NICs cannot connect to Cisco Catalyst 2950 Sw