Hi all,If two tetra cards (GSR GE Linecards) are connected back to back and run ebgp (vrf level) between them. I presume the locally generated bgp traffic (prec 6) automatically goes into the default queue if multiple output queues are present? If th...

When an 802.1q/p FE interface is configured to monitor the Rx traffic of a 802.1q/p GE source port does the SPAN function copy the Cos-bit value or does it remark to zero on a supervisor 2.

I configured SPAN on a switch and attached a network analyser to the destination port. The analyser is recording the recording the L2/L3 information travering the source port, as expected but doesn't seem to be recording the 802.1q/p information. My...

To use a pcmcia card currently being used by a 7500 series router on a catalyst 6500, do I need to format the disk?

Does the policing cir calculation take into account layer 2 overhead or is entirely based on layer 3.