Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I have setup some acl's on my 837 router to secure the router but allow me to access outside hosts from the ethernet interface. I have writen an ACL as follows and applied to the dialer 0 interfaces (since its PPOE) some data has been moved for size;...
Does anyone know where i can find some information regarding the ipsec throughput on one of these routers ? I can't seem to find any information from Cisco anywhere on the site. I'm considering getting the Plus image of IOS on the units as they'll...
I have a 7200 router with a single hssi interface and another fast ethernet interface. IOS 12.2(5). I have enabled cef globably and didn't recieve any errors. I then tried to run a protcol discovery on the main hssi interface however after running a ...
I'm trying to configure a number of Catlyst 2950's (12.1(14)EAa1) using a know good confiugration from a similar switch with IOS 12.0(5.3)WC(1). Each time i configure the IP address on the VLAN1 interface, do a no shutdown and the copy run start an...
Hope this helps. I have included what i think you'd need only but if theres anything else that you think you need let me know. !ip cef!class-map match-all Citrix match protocol citrix!!policy-map 3q-for-citrix class Citrix bandwidth percent 75 c...
It displays the list of default protocols but with no traffic matched against any of the protocols (including unkown). i have confirmed that the sub interface and interface that we are applying the protocol discovery to does actuall have such traffi...
