Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello All,
First off, I'd like to mention that this has been my 1st time touching Cisco configs in the better part of a decade. Needless to say, im rather rusty. Basically what im attempting to do is allow access TeamViewer Only for the time being....
Thanks Again Georg,
It is actually tested and working. I think the reason for this is that TeamViewer has to "phone home" initially to even work. So the Teamviewer connection is always initiated from the internal network. Once that connection is in...
Thank you all for the help. I couldn't have done it without you. All 3 of you contributed useful information that ended with a working finished product. Below is the working config based upon the work we've done in this thread combined with about 200...
Thank you both for you help so far. Unfortunately with the config listed below Is not allowing teamviewer access. Its not letting anything else through either. I think its that I dont fully understand what you mean by "Note: - the below config will N...
Hello,
Thanks again. Sorry for the delay in response. I've been away from this project for a few days.
TeamViewer does use those as fall back ports but only in the event of not being able to connect on the regular ports. I Tried to add those as ...
OK, I tried that. No good on the Teamviewer connection or the DNS for 8.8.8.8. Interestingly enough, Windows thinks it is online... See Screenshot. Teamviewer Still does not. Also, still cannot ping out or the gateway ip.
Current Config Below. vers...
