Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello Everyone, I understand that BGP is currently not on the ASA 5510, 5520, 5540, 5550, and the ASA 5580. I am curious as to why the ASA 5505 supports it and not the models that I listed. I am curious if Cisco has any plans on implementing BGP on t...
Hello everyone,
I am trying to get AS-Path prepending to work on my switch in my network but it isn't prepending the AS as it should be doing per the route-map. This is all within my home lab that I am also using to connect to the internet. I am pe...
Hello everyone,
I am having an issue with my IM and presence server, when I ping someone from my Jabber client (we'll call it Jabber_X) to another user using Cisco Jabber on a different CUCM cluster with the same domain name (we'll use example.com...
Hello everyone,
I am trying to configure my static ip address with CenturyLink.
here is the config that I am using:
interface ATM0/0/0.1 point-to-pointip address 65.40.112.80 255.255.255.128ip nat outsideip virtual-reassembly inip traffic-export a...
Hello everyone,
Every time I reboot my router the WebVPN seems to work fine then it won't allow authentication via AnyConnect nor through the portal. On the web portal, it shows internal error every time I go to connect to it.
Hello Karsten,
Unfortunately I can't upgrade as this is my home lab. It costs about $1400 to upgrade if I buy ASA 5512-X off of eBay (that is where I buy my equipment for my home lab).
Trevor Janssen
Hello Bogdan,
I only wish that they do upgrade the older ASAs to 9.2 so that I can use BGP and retire OSPF. I do understand that BGP was introduced in 9.2 and that the latest version available for the ASAs that I listed is 9.1.7 Interim.
Trevor...
Hello everyone,
I have figured out the issue, it turns out the address was tied to my mom's CenturyLink business DSL circuit and not to my residential DSL circuit, I have a phone call scheduled for tomorrow to call CL and have them change my addres...
My question based on the configuration, how is the router supposed to get DHCP if it falls under the implicit deny ip any any, I would add "permit udp any eq bootpc any eq bootps" into the config so that it can grab an ip address from the provider's ...
