Hello,Before giving it a static IP address, you need to update the codec so that the touchscreen can connect to the codec.To do this, plugged the codec into a network socket which is active in DHCP, note the address appearing in the upper left corner...
Hello,By default, the codec is in DHCP, plug it into an active network socket where DHCP is enabled and the IPV4 address will be displayed in the upper left corner of the home screen.You can then access the codec's web interface with the IP address a...
Hello,I managed to connect through the web interface by connecting it to a network in DHCP and I was able to update the firmware to this 9.15.0.11 aec227943ed.Subsequently, by reconnecting the touch pad, the update was carried out and the problem is ...
This is a new device and this is the first connection to the codec. Not able to configure the codec because touch panel not detected. Could not connect to target system. Wrong target system or is turned off?
